Drawing ellipses

Pins-and-string method

The characterization of an ellipse as the locus of points so that sum of the distances to the foci is constant leads to a method of drawing one using two drawing pins, a length of string, and a pencil. In this method, pins are pushed into the paper at two points which will become the ellipse's foci. A string tied at each end to the two pins and the tip of a pen is used to pull the loop taut so as to form a triangle. The tip of the pen will then trace an ellipse if it is moved while keeping the string taut. Using two pegs and a rope, this procedure is traditionally used by gardeners to outline an elliptical flower bed; thus it is called the gardener's ellipse.

Drawing an ellipse with two pins, a loop, and a pen. 

Trammel method

An ellipse can also be drawn using a ruler, a set square, and a pencil:

Draw two perpendicular lines M,N on the paper; these will be the major and minor axes of the ellipse. Mark three points A, B, C on the ruler. A->C being the length of the major axis and B->C the length of the minor axis. With one hand, move the ruler on the paper, turning and sliding it so as to keep point A always on line N, and B on line M. With the other hand, keep the pencil's tip on the paper, following point C of the ruler. The tip will trace out an ellipse.

The trammel of Archimedes or ellipsograph is a mechanical device that implements this principle. The ruler is replaced by a rod with a pencil holder (point C) at one end, and two adjustable side pins (points A and B) that slide into two perpendicular slots cut into a metal plate. The mechanism can be used with a router to cut ellipses from board material. The mechanism is also used in a toy called the "nothing grinder".

 

Trammel of Archimedes (ellipsograph) animation.

 

Parallelogram method

In the parallelogram method, an ellipse is constructed point by point using equally spaced points on two horizontal lines and equally spaced points on two vertical lines. Similar methods exist for the parabola and hyperbola.

Approximations to ellipses

An ellipse of low eccentricity can be represented reasonably accurately by a circle with its centre offset. To draw the orbit with a pair of compasses the centre of the circle should be offset from the focus by an amount equal to the eccentricity multiplied by the radius.

 

Ellipse construction applying the parallelogram method.